3D, 3 Ways to Mount a Punched Embellishment, and 3 Days Left on this Sale

You can add a 3D effect to your projects with some creative mounting of your punched pieces. 

With tape in hand you might just mount the butterflies flat using the tape. And that would look just fine.

Or consider using a Glue Dot or a small piece of Dimensional Foam to raise the butterfly up a bit and then bend up the wings.  Now you have a butterfly that looks like its flying.

Here is a comparison of the 3 ways to mount a punched embellishment

By the way: the butterfly was created using Stampin'UP!'s Bitty Butterfly punch.  This punch and the matching stamp set - Papillon Potpourri - are part of the September special. 

Save 15% when you get both the Papillon Potpourri stamp set and the Bitty Butterfly punch.

Stop by tomorrow to see another card made with this cute punch.

--Katie